Antique Caned Chair Replaced Seat

 

Caned Chair Before

Caned Chair After

This is an antique parlor chair which had a broken caned seat. It’s not uncommon for this to happen with old caned chairs. They don’t hold up well to a knee or an active child who decides to jump on the chair as if it were upholstered. Caning is pretty durable but does have its limits.

Caning comes in many sizes, so it’s important to measure the holes in the diameter of the chair’s seat and get the caning that fits those holes. This chair had 1/4” holes, so it used 1/8” caning, which is considered medium. Caning also comes in super fine, medium and larger sizes. The procedure is the same, but I prefer working with the medium size cane since it is stronger than the finer sizes and holds up to the pulling and tugging that comes along with installation. 

Chairs get a lot of use, so the upper portion tends to get dirty from the oils from our hands, so they require cleaning and polishing for them to look fresh again. This one needed a good cleaning and a touch up of polyurethane instead of a complete strip. If a full strip isn’t in the budget, a partial strip usually works well. Either way, the chair is always better than it was prior to the restoration. This chair was made of maple, a hardwood, so it will hold up for many more years to come. If you have a caned chair that is a big saggy, simply lay a damp towel on it overnight and it will tighten the caning again to its original tautness. Just a little tip that allows you to get more use out of the chair before investing in a complete cane renovation.