Ship’s Wheel Stripped

Ship's Wheel Before

Ship's Wheel After Stripping

Every once in a while we get an unusual job, not your everyday furniture. This teak ship’s wheel was such a job. He had also brought two other small things, a cup holder and a t.v. remote (or cell phone) holder. The customer had wanted this ship’s wheel to match his boat, so he wanted it stripped only. He would take care of the staining.

I started with the wheel lying flat on the table, then decided it would be easier to work on in an upright position, so I had Jim cut a small hole in my work table and I used this to position the ship’s wheel in it and spun it as needed to get into all the small areas on the spindles. It turned out to be a great idea as it helped me access areas that would otherwise have been very difficult to reach otherwise. This ship’s wheel took a full three days of detailed, time-consuming hand-stripping and sanding to remove the worn, peeling polyurethane.

The wheel had no stain on it, just polyurethane, but had begun to wear off and in some areas had suffered water damage. While sanding, I focused on those areas, but after it was to be stained, it would cover those areas completely. When I had completed the sanding, I took an old toothbrush and used brass cleaner to remove the oxidation from the center, which was made of solid brass. It look great when all that oxidation was removed and with a bit of elbow grease and brass polish, it shined up and looked brand new. This final touch made the ship’s wheel look great.

Ship's Wheel hole in Table