 |
| Caned Chair After |
 |
| Caned Chair Before |
This was a nicely sized, small antique chair with a broken cane seat. This is a common problem with cane, it breaks easily when someone either puts a knee through it or tries to stand on it (not recommend).
This chair was a standard strand weave cane, using a medium size cane. To determine what size cane a chair requires, you measure the distance between each hole as well as the size of the holes on the perimeter of the chair’s seat. If you’re unsure what size to get, it’s better to go a size smaller because ultimately it’s easier to work with.
I prefer this type of caning to the spline, or “press in” caning because although it is more time consuming, it is actually easier to do and much more accurate. I also prefer the look of strand caning to spline caning. The process for spline caning is completely different from strand caning, as the caning comes in a sheet anywhere between 16"-24” wide and sold by the foot, so if you are doing a chair that is 13” x 14” you need to get two lengths of caning in the closest size, but allowing an additional two inches on each side to allow enough cane to “press” into the groove on the top edge of the chair.
With the traditional weave as seen in this chair, you start by removing the old cane completely and make sure all the holes are cleaned out. Then you begin the weave by starting from the front center and coming up the back center, passing beneath through each hole, then back up again to the top, repeating this procedure until one side of the chair is completely filled in, then you repeat on the other side. The next step is the horizontal weaving, continuing until the entire chair is covered both vertically and horizontally. The third step is another row of vertical, this one going slightly to the left of the first row. This allows the additional weaving steps to be easier.
The total process has six steps of weaving then the final step is the final edge which is secured with binding cane which is a bit wider than the cane used on the chair. You come up through each hole then down the same hole, over the binding then securing the it by pulling the working cane through snugly on the underside, then repeating this on each hole until you complete the entire chair. You secure the corners with a 1” piece of round peg cane that keeps the corners from coming apart. On the underside of the chair will be the loose strands of cane which will be tied beneath the woven strands created through the caning process. This is the last and final step before the chair is complete and ready to use.
My first caning chair was quite the challenge, but after watching many videos and reading material, have since done many caned chairs. Each time it gets a little bit easier, because I understand the weaving process. I’m currently self-learning yet a new type of weave, a rush chair, which is a completely different process from caning, since the entire chair is woven from the corners to the center, ending with a very narrow space to fill in the last strand. Rush is either natural or manufactured, but the process is the same. I’m in the early stages of this, but this evening I finally figured out the direction and how to get it positioned correctly. When I’m done I will hopefully will have four nicely finished rush chairs and a new skill under my belt. I’ll be posing those too, so keep checking back!
